2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

brake light comes on 90 percent of the time, losing fluid, and WTF is that smell??

Thread Tools
 
Search this Thread
 
Old Apr 19, 2004 | 12:11 PM
  #1  
Dltreezan's Avatar
Thread Starter
My Bick is Digger
Tenured Member 15 Years
iTrader: (3)
 
Joined: Oct 2002
Posts: 3,509
Likes: 2
From: Raleigh, NC
Question brake light comes on 90 percent of the time, losing fluid, and WTF is that smell??

guys 90 percent of the time my handbrake light is on now and seems that give it more or less gas sometimes it turns on or off, much like the rest of my gauges in that cluster now, could be coincidence. I am also losing brake fluid and i checked all of the lines in the wheel wells and i dont see any leakage so where the hell else would it be if it isnt on the master cylinder? And maybe that smell is the fluid burning off of the cat? BTW - my handbrake is really weak
Reply
Old Apr 19, 2004 | 12:37 PM
  #2  
dr.jones63's Avatar
It's a Hammer
Tenured Member 10 Years
 
Joined: Jul 2002
Posts: 998
Likes: 0
From: Richland WA
If your brake fluid reservor is low that turns on the brake light on your logicon. The way the shops find a brake fluid leak is to put a blacklight dye in your brakefluid. Your hand brake is not hydraulic. Its mechanical.
Reply
Old Apr 19, 2004 | 12:41 PM
  #3  
YearsOfDecay's Avatar
Locust of the apocalypse
Tenured Member 05 Years
 
Joined: Apr 2003
Posts: 2,553
Likes: 2
From: Directly above the center of the earth (York, PA)
You car have ABS???? of so... look under the ABS motor...

I found that all my brake fluid was running down onto the frame rail and eating the paint off before dropping to the ground (and getting on the midpipe as well).

Check the brake lines that run down under the car, could be leaking.

As for your handbrake... check the rear brake pads.. the handbrake is mechanical, shouldn't be affected by low fluid. I bet your rear pads are shot.
Reply
Old Apr 19, 2004 | 01:14 PM
  #4  
My88Se's Avatar
Senior Member
Tenured Member 20 Years
iTrader: (10)
 
Joined: Sep 2002
Posts: 469
Likes: 0
From: Chicago
Yea I just changed my rears. You might wanna just tighten up the cable. take the screw out of the handbrake lever and take the cover off. just need a flathead to tighten it up.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
fastsaab
New Member RX-7 Technical
5
Aug 19, 2015 11:42 AM
Frisky Arab
2nd Generation Specific (1986-1992)
13
Aug 18, 2015 05:30 PM




All times are GMT -5. The time now is 06:56 AM.