Which BOV w/stock I/Cooler?
#1
"Just Looking".......
Thread Starter
Join Date: Jul 2001
Location: Treasure Coast, FL
Posts: 521
Likes: 0
Received 0 Likes
on
0 Posts
Which BOV w/stock I/Cooler?
I've heard a couple of these last week - one on a '90+300ZXtt and another on a WRX.
Which is a good one to get as far as sound (preferably louder) and installability. I'd like to minimize fabricating stuff.
Where exactly to mount it, etc would be helpful.
Which is a good one to get as far as sound (preferably louder) and installability. I'd like to minimize fabricating stuff.
Where exactly to mount it, etc would be helpful.
#2
Passenger
Posts: n/a
Ive got the greddy type s, Sounds so bad ***, and was easy to intsall. Just remove the cast aluminum ic pipe where the old one was, "you can either put it there or if you don't have an airpump put it in front." that made fitting it in easier for me, and just cut a hole, get an aluminum flange, and tig weld it on, and then weld up old bov hole in pipe and stick a rubber cork from the hardware store in the intake pipe, It was easier than sounds. But gets lots of attention going down the road, And most hondas just back off, and don't try to rev on me now.
Thread
Thread Starter
Forum
Replies
Last Post
Devon300zx
2nd Generation Specific (1986-1992)
3
09-17-15 03:50 PM