Does someone know the specs on the bolts that bolt the pressure plate to the flywheel on a OEM s4 Turbo II?

I ordered them from mazdatrix and after a week of waiting they sent me the wrong ones. So I want to source them from a local source.

Thanks in advance

 

I'll check the manual again, but I didn't see it in there.


This is the only thing I need before I can get the motor in and running, and I was really hoping on getting it in today.....

 

natey..here ya go..a pic of one of the Longer bolts..note the number on top of the head of the bolt
NOTE that some of the bolts used have no thread past a certain point..there are I think 4 shorter bolts that are threaded all the way to the Head..2 are not threaded all the way.So Try not to Force them on if they do not go in all the way..

 

Went to the hardware store and bought a variety of bolts and found the right ones. IIRC it was M8/1.00

 

Was on the master list in the archives.

 

uhg fml, I even looked there

 

ummm I'd very sure that you're using grade 10 bolts. the stress put on these bolts and the RPM they spin at is something you shouldn't mess around with.