blinker doesn't go off by itself after steering wheel removal
#1
Senior Member
Thread Starter
Join Date: Jan 2003
Location: franklin, MA
Posts: 345
Likes: 0
Received 0 Likes
on
0 Posts
blinker doesn't go off by itself after steering wheel removal
ok, i took apart all of my dash and what-not, and then i put my steering wheel back on and everything was fine except that when you put the blinker on and after you turn, it won't go off by itself anymore. i have to manually turn it off. what did i not connect or hook up behind or inside the steering wheel for this to happen...
#3
Senior Member
Thread Starter
Join Date: Jan 2003
Location: franklin, MA
Posts: 345
Likes: 0
Received 0 Likes
on
0 Posts
well it works fine, it just won't go off by itself anymmore and i didn't touch it at all, i think its in the steering wheel, something i didn't hook up so it will click off when i spin the wheel back
#6
Former Moderator. RIP Icemark.
You didn't align the steering wheel correctly or damaged the position sensor when you installed the wheel back on.
There is a wheel position sensor mounted on the column that the power steering computer and CPU uses to detect wheel angle. The CPU uses it also to send a signal to cancel the turn signal when you turn the wheel far enough and then back.
Just pop the wheel off and re-align it. You should see the switch once the wheel is removed. It has a small white tap sticking up.
There is a wheel position sensor mounted on the column that the power steering computer and CPU uses to detect wheel angle. The CPU uses it also to send a signal to cancel the turn signal when you turn the wheel far enough and then back.
Just pop the wheel off and re-align it. You should see the switch once the wheel is removed. It has a small white tap sticking up.