ok i'm told to get a banjo bolt for my rx and cap the PD instaead of replacing it will i looked at what both would cost and that the pd would probibly go out again so what i'm asking is what size bolt am i'm going to need and were can i get one thx guys it's been great so far

 

jack daniels,

You should have searched for this, it's been covered ALLOT:

https://www.rx7club.com/showthread.p...hreadid=216694

The part you want is:
http://store.summitracing.com/defaul...7591&x=14&y=10

And you may decide to use copper crush washers instead of the supplied aluminum ones.