BAC help!!
#2
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
Connect the bac to its electrical connector. Turn the key to ON. The bac should vibrate.
If it does not, then see if you have 12v on the electrical plugs black/white wire.
If it vibrates with the key to ON, it is working. Spray some carb cleaner in it while it vibrates and then dump the fluid. Repeat to your hearts content.
You could also ohm it out from pin to pin. It should read about 10-12 ohms.
If it does not, then see if you have 12v on the electrical plugs black/white wire.
If it vibrates with the key to ON, it is working. Spray some carb cleaner in it while it vibrates and then dump the fluid. Repeat to your hearts content.
You could also ohm it out from pin to pin. It should read about 10-12 ohms.
Last edited by HAILERS; 08-31-05 at 07:48 PM.
Thread
Thread Starter
Forum
Replies
Last Post
PinkRacer
2nd Generation Specific (1986-1992)
43
10-01-15 09:13 AM