Aw man..time has come, motor blew?
#1
Full Member
Thread Starter
Join Date: Feb 2007
Location: So-cal
Posts: 200
Likes: 0
Received 0 Likes
on
0 Posts
Aw man..time has come, motor blew?
Earlier tonight i started up my car, then something completely different happen than usual, my car started with massive rumbles and remained at super low rpm, i tried to kick up the rpm a bit by putting little amount of gas to it, as i barely gassed it, rpm barely even had any effect of moving up. and while gassing a little, my car backfired 3 times like never before, 3 sparks of flames my friends from behind said.. i turned off my car because thr strangeness was messing with my head, now my car wont start at all.
I hardly ever abuse the car, RARELY ever bone out or mess around with it. oh btw it has 159xxx on it. maybe a word from you experts to verify that my motor is blown or there is another problem with it?
plans for the future...part out or try to sell the shell
any opinions, advice would be greatly appreciated Thanks rx7club!
I hardly ever abuse the car, RARELY ever bone out or mess around with it. oh btw it has 159xxx on it. maybe a word from you experts to verify that my motor is blown or there is another problem with it?
plans for the future...part out or try to sell the shell
any opinions, advice would be greatly appreciated Thanks rx7club!
#3
Full Member
Thread Starter
Join Date: Feb 2007
Location: So-cal
Posts: 200
Likes: 0
Received 0 Likes
on
0 Posts
sounds reasonable, because before this happened my car always had that crazy amount of smoke problem when at high rpm's (the thing where people said either it was my coolant seal or apex seal)
#7
^well said.
to see objectively for ur self. remove the top or bottom spark plug of one housing, disable ignition and crank for a few seconds. is it uneven pulses? then replace and repeat for other housing. good luck with ur future plans.
to see objectively for ur self. remove the top or bottom spark plug of one housing, disable ignition and crank for a few seconds. is it uneven pulses? then replace and repeat for other housing. good luck with ur future plans.
Thread
Thread Starter
Forum
Replies
Last Post