I need some help, or information on installing a clutch pedal, like are the holes for the clutch pedal already under the dash, or do I have to drill them? Secondly, does anyone know of a place that sells a kit with the cylinder/pedal/bushings/release cylinder/etc? Thanks for any info!

 

I did this little trick and it was a royal bitch. You're best bet is to have a complete other junk car to **** with. You can exchange the pedal assemblys and all the other ****, it will all bolt right up. You have some wire **** to worry about and I wasn't able to get any reverse lights after the conversion. Your main problem will be transmission mounts. I had to cut them out of the junk RX. Took a few days to do all this. Good Luck.

 

Uh, didn't like your original post?

 

I answered my first original question so I changed it to suit a series of next.

 

Refer to this post, I wish you could change thread names!

https://www.rx7club.com/forum/showth...threadid=49109