Mint87RX7

well my antenna was snapped when i got my 87 so when i got my parts car ( a 90) i took the shaft out of that antenna and used my antenna motor from my 87. this was like 6 months ago so i cant remember what parts are different. but the problem is, the antenna raises up and does not stop, it just shoots out of the car. what i would like to know is, what catches the base of the antenna to keep it from sliding all the way out. and also, does the lowest part of the antenna shaft ( the thickest section) raise all the way up or stay inside the alluminum casing to support the raised section. any pics of a dissasembled antenna would be GREAT.

Icemark

The part that keeps it from sliding out is the top shaft mounting nut. It locks the shaft contact into the antenna body as well as the antenna shaft to the car body.

Mint87RX7

is there a piece in he nut like a washer that could have fallen out? and is it the same thing from s4 to s5? it just seems like it would be very unstable if it was just that little lip on the antenna shaft keeping it from falling out. but anyway, the black mounting nut on mine is to large to have contact with the shaft

Icemark

sounds like you are missing the mast sleeve/shaft contact. It is on the mast, and electrically connects the mast to the body of the antenna.

Mint87RX7

i wish i had a picture to look at. i think you are talking about the little green box that clamps onto the mast, that is on there right. i must be missing something inside the mast or the mounting nut that goes above the body is different on an s5.

Mint87RX7

ok i found some pics of it, im missing the locating sleeve. and while looking at the pictures i remembered that the car i took it off of had a wing so im sure there are some different parts to accomedate the extra inch of spoiler. heres a pic of the part, is this the same on an s4?

Icemark

should be the same part on any harada antenna, series doesn't matter