I need a good 12v+ switch point for the haltech install...I tried the radio piont with a relay to the battery( so I wouldn't overload the circuit I've done that before!!!) It didn't work I need a point that stays on while cranking...any suggestions???

 

there are two that feed the stock computer. One is constant the other one isn't. Try the Green with yellow stripe.

 

oops sorry its a 1991 vert with a 13b-re swaped into it....stock computer is gone along with the harnes...any ideas about a switch and push button start....I thought that might be a little dangerous...just in case someone tries to drive my car...its kind of funny turning the key off and everything goes off except the engine!!!!

 

go in the drivers side. there should be a loose plug hanging somewhere arround the steering column. anyway it is like a 10 or 12 pin square plug. use the black with a green stripe one. this one actually works only on the on position in the switch just like the stock ECU.