Anyone have aftermarket coils?
#1
Engine, Not Motor
Thread Starter
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Anyone have aftermarket coils?
Just wondering if anyone is running aftermarket ignition coils in addition to a CDI box? I'm considering getting two Crane coils and paralleling them to replace the stock leading, but I just want to hear about other's experiences...
Thanks!
Thanks!
#2
Senior Member
Join Date: Mar 2001
Location: Lawrenceville,Georgia,U.S.
Posts: 501
Likes: 0
Received 0 Likes
on
0 Posts
Hey, I haven't got it in, but I'm getting there! The setup I am installing is as follows: 2 Crane Hi-6 CDI units driving 2 Crane PS-92 CDI only coils. I considered using a single Hi-6, but this would have reduced the available energy/spark by 1/2 on each coil, and in addition would have shortened spark duration. Do not consider paralleling PS-92 coils, they have too low an impedance and will blow out a single Hi-6. However, a single Hi-6 can drive 2 PS-91 universal coils with no problem. The above mentioned limitations still apply, of course. I will post results when the installation is completed.
Irv, Keith's dad
Irv, Keith's dad
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM
SakeBomb Garage
SakeBomb Garage
0
09-04-15 05:20 PM
SakeBomb Garage
Vendor Classifieds
0
09-04-15 05:19 PM