aftermarket seats
Thread Starter
Full Member
Joined: Dec 2001
Posts: 78
Likes: 0
From: KC
aftermarket seats
I like the seats in my convertible but I am looking at a cost of $6-700 just do get new leather put on them. Has anybody had any luck with any aftermarket seats? I found some nice corbeaus for $900. Recline and everything. Any ideas?
Re: aftermarket seats
Originally posted by Ericdrivesrx-7
I like the seats in my convertible but I am looking at a cost of $6-700 just do get new leather put on them. Has anybody had any luck with any aftermarket seats? I found some nice corbeaus for $900. Recline and everything. Any ideas?
I like the seats in my convertible but I am looking at a cost of $6-700 just do get new leather put on them. Has anybody had any luck with any aftermarket seats? I found some nice corbeaus for $900. Recline and everything. Any ideas?
Trending Topics
I got my corbeau forza's for about 600 for the set w/ brackets and 2 harnesses (we're a dealer though hehe). sure, they make brackets for the car but they are NOT pplug and play...they stink and the wholes are all off which means it requires some patience and a prybar to get them to fit the way they are supposed to. the forza is a racing bucket (i got black w/ black wear patches) meaning it doesn't recline but it's stil comfy and BOY is it light!!!
I put some vert covers on Ebay- http://cgi.ebay.com/ebaymotors/ws/e...2410424937&rd=1
i just put seats in my convertible earlier this week. they are a little tall and scrub the ceiling barely but the top goes down no problem. they are APC seats, sorry guys i dont have much $$$, but im stoked they fit tightly and with an aftermarket headrest or pillow the APC will be covered up.
as far as putting them in i had some problems with the passenger side cuz the mounts arent level from left to right so at first is sat sloped but i figured it out and its not to shabby
Ericdrivesrx-7 personally id go aftermarket but take measurements before you buy cuz our verts are quite tight in there
good luck
have fun
as far as putting them in i had some problems with the passenger side cuz the mounts arent level from left to right so at first is sat sloped but i figured it out and its not to shabby
Ericdrivesrx-7 personally id go aftermarket but take measurements before you buy cuz our verts are quite tight in there
good luck
have fun
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM



