Are there any out there? These rubber ones are pretty ugly. Grip tape is ghetto in my book. I'm think of brushed aluminum style. A dead pedal would be nice too.

 

I have peddles on mine there a clip over so it gives it a look but I wish it was the actual paddle

 

These are technically pedal covers. I know of no aftermarket pedals that would actually replace the stock units.

Autovation Technologies - RX7 Race Pedals

 

I wonder why the polished ones are $30 cheaper than the matte.
That seems backwards.

 

Those are pretty swanky, I was expecting cheapo ugly clamp-on Walmart style ones when I clicked the link

It does seem odd that the matte finish ones are $30 bucks more, and it sucks that those are the ones I want ha ha

-sean

 

the polished probably comes like that and they just cut it, the matte requires someone to put it in a blast cabinet. That would be my guess.

Used to be a forum member who made those YEARS ago before everyone else did. I got the very last set from him

 

Sounds reasonable.
Still, $30 for ten minutes of cabinet time is excessive (assuming they're blasted not tumbled, which should be even cheaper).

 

you could always do it yourself

 

The brake and clutch pedals are aluminum under the covers. I took mine off and drilled them then added grip tape. You said you didn't like the grip tape but if you could figure out to give them a brushed look you might be in business. I got my gas and dead peadals from a kit and added the grip tape to the gas. Here is a picture though tape is worn some andhas some mud on it.