after emissions/ratnest removal????
#1
REST IN PEACE DAVE!!!!!!
Thread Starter
iTrader: (7)
Join Date: Sep 2003
Location: las vegas.nevada.
Posts: 1,673
Likes: 0
Received 0 Likes
on
0 Posts
after emissions/ratnest removal????
in what places the the vaccum lines go on the back of the upper intake manifold,i know all 3 on the front get capped,and i know the big one on the back goes to the oil injectors...please help asap thanks
#2
Full Member
iTrader: (1)
Join Date: Oct 2002
Location: Prince George, BC
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
I'm not too sure which model you have but it sounds like you have nothing left to do but cap a whole pile of old vaccum lines and then run a new line from manifold vaccum to a tee and from the tee run a line to your pressure sensor and to your fuel pressure regulator and you should be good to go. I guess you don't have to use the tee, you could probably run both to seperate sources of manifold vaccum.
#3
REST IN PEACE DAVE!!!!!!
Thread Starter
iTrader: (7)
Join Date: Sep 2003
Location: las vegas.nevada.
Posts: 1,673
Likes: 0
Received 0 Likes
on
0 Posts
yes its just wierd in the manual it say the fuel pressure regulator line goes to the nipple down by the injectors but its not???? i just need to find out where 1-4 on the back of the upper intake manifold go 1 being the top one 4 being the bottom...thanks
#5
Full Member
iTrader: (1)
Join Date: Oct 2002
Location: Prince George, BC
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
I just did a quick look for you and it seems that it doesn't matter. Every one that i've seen so far including mine has all of the UIM lines capped unless you are using them for something else.
Thread
Thread Starter
Forum
Replies
Last Post
Erosangel
3rd Generation Specific (1993-2002)
5
09-18-15 04:06 PM