i have a aem wide band any body know where i can get information about the installation of the gauge in picture or word form

 

its on AEM's website you can download the book that comes with it

 

It's very simple. The only thing you really need to know is the sensor should be 36inches back from the start of the exhaust. Esp if you have cats. I guess you would need to know what colored wires do what. There is one conector that has 4 wires 1+ & 1- while the other 2 are used for aftermarket ECU.

 

i just picked up i havnt installed it yet though could u replace the stock o2 sensor with the wideband then run the 0-5v wire to the ecu?

i wasnt going to do that but i just figured it might work

 

Stock cats + putting the sensor in the o2 location would mean bye bye sensor. If you have the stock exhaust I would say before the cat. Just have a hole drilled in the exhaust pipe. The aem kit comes with a bung.