2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

87 T2 (S4) Exhaust Question

Thread Tools
 
Search this Thread
 
Old Feb 10, 2006 | 08:35 PM
  #1  
Phantomhp's Avatar
Thread Starter
Rotary Enthusiast
Tenured Member 05 Years
 
Joined: Jul 2004
Posts: 881
Likes: 0
From: Lubbock,Tx
87 T2 (S4) Exhaust Question

Hey, just installed a full exhaust from downpipe back and was curious as to the effects there will be since there is no place for that tube that goes from the side of the engine down to the side of the cat.

I am unsure if that is fully needed or just get a block off plate and be done with it?

Thanks,
Mike
Reply
Old Feb 10, 2006 | 08:38 PM
  #2  
adrock3217's Avatar
Boost in..Apex seals out.
Tenured Member 10 Years
 
Joined: Nov 2003
Posts: 1,931
Likes: 0
From: Maryland, 21794
That pipe pumps air from the airpump down into the cat. It lower's emissions. Without it, you can remove the airpump, and ACV-note, this will require a blockoff plate. And BE SURE you seal the blockoff plate really well with RTV, as it is known to leak on lots of cars.
Reply
Old Feb 10, 2006 | 08:41 PM
  #3  
NZConvertible's Avatar
I'm a boost creep...
Tenured Member 05 Years
 
Joined: Jan 2002
Posts: 15,608
Likes: 8
From: Auckland, New Zealand
If you have no cat (or the new cat has no air injection port) then you don't need that pipe, or the air control valve of the side of the manifold, or the air pump. You might as well remove them if you haven't already.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
Mar 28, 2017 03:30 PM
msilvia
3rd Generation Specific (1993-2002)
28
Apr 14, 2016 12:58 PM
12abridgeport
1st Generation Specific (1979-1985)
2
Aug 17, 2015 06:28 PM




All times are GMT -5. The time now is 09:11 AM.