I bought some injectors from the classifieds that were advertised as 720's. I was just assembling them into my car this morning and noticed that the clips didn't fit. After some investigating I have discovered that the part number seems to indicate that they are 690 injectors (Denso 195500 0830). I have an 88TII so these injectors will not fit stock (I will have to shave the clip and wire in a resistor now). I am assuming that using these with the RTek 1.7 I have installed will be a problem. Am I missing something here?
Thanks

 

Yes those are same one's greddy sells as 720's.Apparently they are not that consistent in flow,and I think it is witch hunter fuel injection that rated them with that pic (ave. flow from their experience).BTW those mazda GSL-SE 680cc injectors will flow 700cc plus at 3 Bar pressure that seems to be the standard flow test .

 

Thanks, It looks like I have no worries here. Appreciate the feedback..the rebuild is on!