I can't find the bottom view of the momo hub for our FC. I found picture for the front and never saw the bottom. Well or answer this question does the momo hub bottom have a little **** that sticks out like the stock one does on the steering wheel.

 

NO.it is Flat..The Bottom Outside Is a Copper "contact Ring" thet would be For the horn,I believe.On the Inside is a Small Circular Piece.about the Size of a Dollar Coin(US Silver dollar)..in the Middle is where the Spline of the Steering column would go in,and towards the outside is Two holes,(say at 9 oclock and 3 oclock Position) Those holes are For the Plastic Ring that is Used to cancel your Signal Lights(flashers,left and right).It should be on teh OLD steering wheel when you take it off..If that Plastic piece is not installed,then the Flashers will not Cancel when you have completed a Turn(that is with the New Hub and wheel On)...I hope that Explains it without photos.good luck!

 

somethig like this for any after market hub. that it like a ring or **** that sticks out.

 

I know what you talking about the plastic thing that cancel the signal and stuff. My problem is the sparco hub is pushing up against too close to the steering column towards the back and seem like is not smooth at all. I took it off and put back the stock one in there and it works fine because of that lil **** that sticks out.
thanks for reading.

 

I found the hub that I'm talking about

http://www.shopmomo.com/5705.html

this is the one I have and it doesn't have that lil **** that sticks out

 

anyone have this hub on their FC, they said it will fit the FC but how come not on mine?

http://www.shopmomo.com/hubadapterapp.html do you think base on this chart the hub I bought is for FB 80-85, bceause base on the link it looks like my hub. I bought mine from cardomain and I don't have the recipt to return it. Part # for the MOMO hub for the FB is 5702 and for FC is 5705.