krazykoncepts

I am buying a s5 n/a engine that has been street ported but I was wondering how good of a street port it actually is. Then car was track and ran a 15.8 is that any good? It had a cone intake and a clutch with everything else stock including the exhaust.

ddub

Sounds like a fairly mild port, or something else is wrong. But I guess with stock exhaust it could be choking it, hard to say.

KNONFS

iTrader: (14)

Tell us the MPH at the end of the 1/4, times doesn't really tell you anything if the driver is not good at darg racing

krazykoncepts

what a stock s5 n/a supposed to run?

i dont know the mph at the end

ddub

~16.5 depending on driver and conditions, could be more or less.

I hit 14.9 on stock port with 155k mile engine. Full exhaust, intake, weight reduction, ported manifolds, stripped 6pi system.

bigturbo

Id bet the stock exhaust is the main problem. Get a full headers, high flow cat and cat back systema dn ill bet you drop your times a lot

BDoty311

Something is wrong. Most likely the driver. Hell you can run a 15.8 with a header and intake. Something mechanical could also be wrong.

Try to find out the trap speed, that should be able to clear up some stuff.

vipers

iTrader: (8)

deleted

bojangles

Streetport + stock exhaust = little gain, correct?
I always thought that you weren't utilizing the potential without a freed up exhaust.

vipers

iTrader: (8)

that sounds off to me....... 15.8 is only .7 less than stock......... a descent port job should get you in the low 15's...... must be driver error...... or mechanical error...... even with a choked up exhaust, that time should be better

krazykoncepts

The engine is already pulled from the car so when i pick it up how can i test to see if anything is good?

andrew lohaus

mines stock block and it ran a best of 15.75 i could have shaved a tenth or two off that even if my diff and clutch werent on the verge of crapping out (this was also before any of the weight redux in my sig). it realy is all in the launch. dont expect to see your cars lowest times until youve done about a dozen hard launches and realy get the right technique for your set-up down.

get an exhaust and intake on there, a streeport is going to waste without them

slpin

iTrader: (9)

i say choked exhaust....

88IntegraLS

Stock exhaust really chokes rotaries. I'd bet you would lose at least a second in the 1/4 by swapping in something better. Just adding a racing beat header to my streetported n/a, even though I still had my krusty old stock main cat and cat back, was worth .6 seconds.

'89Vert

exhaust...just my .02

jacobcartmill

iTrader: (6)

full exhause/header does alot for a rotary, especially a streetported one.

totallimmortal

I ran a 15.2 in my stock port s4 with only intake and eshaust. so 15.8 seems slow for the alread higher power s5 + a streetport. with intake exhaust(not cats) and a header you should be able to run solid 14s at least. You may also want to invest in a SAFC or standalone to get the full potential out of your motor since once you add some other mods it will most likely run rich

flamin-roids

So how come no one mentioned elevation? Here in Utah a 15.8 in a N/A anything is pretty good.

slpin

iTrader: (9)

^^^ this guy knows what he is talking about!

vipers

iTrader: (8)

tooshay!!!! elavation is a major role in e.t. times!!!!! kudos to you!!!!