[B]I need serious help guys..[/B]
#1
RR
Thread Starter
Join Date: Jan 2005
Location: Bronx
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
[B]I need serious help guys..[/B]
I just finished rebuilding my engine for my TII and am in the process if breaking the engine. Today @ 924 A.M. I was heating up the engine and the car just stopped running. I re-tried to start, I thought to myself, Ohh that's cause of the breaking in process. So I cranked up the TII and nothing happened. I checked if there's if fuel pressure and it had pressure. Then I checked if there's spark. Nothing comes out from the spark plugs. So i check the fuses located in the engine bay. All were fine. So I checked the fuse under the driver's side. All were also fine. I tried a different computer and that's not the only problem, I also checked the main relay. That was also good. I checked if there's power to the crank angle sensor, and there's not power. Then I noticed that the four cables that connects the crank angle sensor they were split open and tied up together causing something to SHORT OUT. Plase Is there any relay i can checked please if you want, please call me 347-393-9079. My name is Robert.
#3
RR
Thread Starter
Join Date: Jan 2005
Location: Bronx
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Well, I seperated the for wires that connects to the crank angle sensor and tried
it again and still nothing. Then I kept checking the wires to see where it stops getting power. I went as far as the fire wall and no power was still received. I trued replacing the ecu, but that was not the problem.
it again and still nothing. Then I kept checking the wires to see where it stops getting power. I went as far as the fire wall and no power was still received. I trued replacing the ecu, but that was not the problem.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM