kagoostin

iTrader: (1)

Hey guys i was curious where i can buy the bottom bushing that wraps around the small ball at the bottom of the shifter. Looked on most sites but can't find one.

Was also wondering if the tranny shift control needs to be replaced as much as the bushings.

Thanks guys.

DCRotor

iTrader: (2)

Mazdatrix.com?

kagoostin

iTrader: (1)

Can't seem to find them on mazdatrix or ebay.

HotRodMex

iTrader: (3)

MMR-direct sells a replacement.

kagoostin

iTrader: (1)

Yeah thats the only site i seen it on. Was alittle confused cause it says: replaces the OEM rubber bushing found between the shifter ball and shifter socket. I was thinking isnt that just the shaft inbetween the two *****?

Landon303

iTrader: (25)

https://www.rx7club.com/2nd-generation-specific-1986-1992-17/mmr-direct-lower-shift-bushing-too-tall-919978/

Read through here, just went through this on my car lol

kagoostin

iTrader: (1)

What is the oem block that mazdatrix sells?

kagoostin

iTrader: (1)

Was also wondering if someone could verify if this is a short shifter that the previous owner put on it.

RXSpeed16

iTrader: (41)

A short shifter will have a spacer block like the one in the left of the rx7store picture. No spacer = no short throw shifter.

kagoostin

iTrader: (1)

Is it this?

RXSpeed16

iTrader: (41)

Bingo!