Squeeb's Convertible
#76
DONT FEED THE NOOBS
Join Date: Mar 2001
Location: land of slow hondas .... TULSA, OK
Posts: 1,270
Likes: 0
Received 0 Likes
on
0 Posts
#80
Senior Member
Thread Starter
iTrader: (4)
Join Date: Mar 2008
Location: Everett, WA
Posts: 645
Likes: 0
Received 0 Likes
on
0 Posts
Kirk Racing's 4 point roll bar, and im gonna have them add a harness bar to it. Top will still be functional but you will have to remove the targa section when putting the top down.
#82
Senior Member
Thread Starter
iTrader: (4)
Join Date: Mar 2008
Location: Everett, WA
Posts: 645
Likes: 0
Received 0 Likes
on
0 Posts
The seat brackets/sliders were made by Wedge Engineering - www.wedgeengineering.net, was easy just bolt them on and in, no fitment issues at all
#87
FC guy
iTrader: (8)
The seat brackets/sliders were made by Wedge Engineering - www.wedgeengineering.net, was easy just bolt them on and in, no fitment issues at all
#91
Senior Member
Thread Starter
iTrader: (4)
Join Date: Mar 2008
Location: Everett, WA
Posts: 645
Likes: 0
Received 0 Likes
on
0 Posts
Thank for the compliments and input. I decided to take a break from the car and finish paying some bills off, now that the bills are taken care of i'm back to working on the car.
I have done a little stuff here and there but nothing major, got some 25mm spacers for the rear so the wheels look more flush, picked up a new shift/e-brake boot (suede w/red stitching) should go nicely with the seats.
Should have mirrors and skirts very soon, decided to go with Re-Amemiya mirrors but not sure on skirts yet still looking - any idea's on skirts welcome
I have done a little stuff here and there but nothing major, got some 25mm spacers for the rear so the wheels look more flush, picked up a new shift/e-brake boot (suede w/red stitching) should go nicely with the seats.
Should have mirrors and skirts very soon, decided to go with Re-Amemiya mirrors but not sure on skirts yet still looking - any idea's on skirts welcome
#95
Senior Member
Thread Starter
iTrader: (4)
Join Date: Mar 2008
Location: Everett, WA
Posts: 645
Likes: 0
Received 0 Likes
on
0 Posts
I was actually planning on doing this but not having any luck finding Odula skirts, only place I found so far that made them was JKL Engineering and from what im reading in their vendor thread it sounds like they are having some business issues.
#96
Shooting for 500
iTrader: (3)
Skirts
Carbon. http://www.rhdjapan.com/odula-carbon...tep-fc3s-56032
The price can get a little steep on the carbon, but it is still less than a grand to your door.
Josh