NA engine bay pics
On the fasttrack!
iTrader: (22)
Joined: Oct 2006
Posts: 2,494
Likes: 2
From: virginia beach, virginia
from my mistress:
FROM THIS

to this

then into the comet (not nearly done, will post new pics asap)

done, except for the new new engine pics

ya, ill have new pics up from the comet when i get it back in a week or so
Lloyd
FROM THIS

to this

then into the comet (not nearly done, will post new pics asap)

done, except for the new new engine pics

ya, ill have new pics up from the comet when i get it back in a week or so
Lloyd
^ did you pull it to paint it? should have did a nice port job when it was out of the car. dont forget to top off the brake resivour and bleed the brakes befor you hit the road...looking a little low
awhile back post
the taurus e fan was free. make sure you wire in a thermostat and relay to turn it on at a set temp. relay and thermostat wire and connecters cost about 20. good mod lots of airflow even when the fan is on the low setting.

awhile back post
the taurus e fan was free. make sure you wire in a thermostat and relay to turn it on at a set temp. relay and thermostat wire and connecters cost about 20. good mod lots of airflow even when the fan is on the low setting.
On the fasttrack!
iTrader: (22)
Joined: Oct 2006
Posts: 2,494
Likes: 2
From: virginia beach, virginia
Uhhhhhhhhh, no. Different car, and why would I pull apart the engine and rebuild it just cause I pulled the engine? And like I said, those pics are not new new pics. I replaced all the hydrolics in the engine bay, wires, hardware, ect. Ill have new pics soon when I get my back from my friends shop
Lloyd
Lloyd
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
Sep 5, 2015 10:23 AM






