Custom Cut, Welded, and Awesome.
Custom Cut, Welded, and Awesome.
Thread Starter
Junior Member
Joined: Jan 2013
Posts: 17
Likes: 0
From: Florida
If enough interest grows in these, I can start a thread in the classified / parts section! I can make more of these!
In this I used aircraft grade aluminum. I used existing holes to bolt through, this required 0 drilling into the car!
In this I used aircraft grade aluminum. I used existing holes to bolt through, this required 0 drilling into the car!
Senior Member
Joined: Sep 2004
Posts: 277
Likes: 1
From: Vancouver
In the one picture it says MOOS MOOS.
On another note, is a wing going on top of these? Did you just bolt this in place where the license plate would go? If you're going to be seeing any sort of downforce on this you're going to destroy that thin bit of metal behind the license plate.
On another note, is a wing going on top of these? Did you just bolt this in place where the license plate would go? If you're going to be seeing any sort of downforce on this you're going to destroy that thin bit of metal behind the license plate.
Thread Starter
Junior Member
Joined: Jan 2013
Posts: 17
Likes: 0
From: Florida
In the one picture it says MOOS MOOS.
On another note, is a wing going on top of these? Did you just bolt this in place where the license plate would go? If you're going to be seeing any sort of downforce on this you're going to destroy that thin bit of metal behind the license plate.
On another note, is a wing going on top of these? Did you just bolt this in place where the license plate would go? If you're going to be seeing any sort of downforce on this you're going to destroy that thin bit of metal behind the license plate.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
Under PSI
3rd Generation Specific (1993-2002)
19
Sep 23, 2015 11:47 PM