Was going on Rotary compadres,
Im very confused know, I bought a project car from my friend with a 20B in a FC.I had a Microtech ltx-12 laying around with 6 microtech bosch coils.The thing is I dont know how to wire all this stuff together? And the car came with just motor and tranny, but no engine harness? What else is needed other than the engine harness? And does the engine harness need to be wired to microtech?And to get my dash cluster working how do I wire the dash harness to the ecu?This 20B swap **** is more complicating then I thought.Can I use a aftermarket igntion system, like( Jacobs) with my Microtech for a more powerfull spark? And how many of these would I need?I know you guys can help in this forum I want to get this beast running.And to those who want to know its goig to have a single turbo setup(HKS T51R).

 

we use an LTX12 on our 20b FD with the stock coils, it was bought new and comes with a new loom that you wire to the engine. The microtec instructions are very good and there isnt much wiring. I would contact microtec and see if you can buy a loom and down load the instruction. Or get the instructions and make a loom, there isnt much to the loom, you have 6 injector plugs, tps, CAS, water temp, air temp but you dont need it and a few others.

The speedo works from the gearbox so that will work,
The water temp is the same as is the oil pressure
The Tacho may not work but we use an autometer one.

Its not too difficult, just get the instructions.