Car is at my residence. Must be experienced in Rotory engines and performance. Car is 80% done and have most parts.. Subframe done, Engine is in, New 20b Turbos installed. etc.

Needs Injectors put in, radiator, fans and piping, Eng. Management system needs to be installed. Battery needs to be relocated , AC, etc etc etc

I will pay as you go and will will work out a payment plan..but again you must be experienced and have your own tools. Prior 3 rotor experience is a major plus.

PM me if interested.

I reside in the St petersburg, Tampa Bay Area

 

Pettit Racing
1300 Old Dixie Highway
Lake Park, FL 33403

try these guys although the one installation I saw from them with a 20B was absolutely ghetto. For instance, they used speaker wire for the fuel injectors to the EMS... OMG!

Did you still need an EMS or do you have one? If you need one, I have a TEC 1 that already has a wiring harness done and you would just need to bolt it in. It also comes with the coil packs and a tuned base map for a 20B.

 

In all reality you are maybe 20% finished. You still have a very long way to go especially ECM isnt wired ane your IC piping and raditor mounts are not finished. Hope you have lots of money to burn becouse fabrication isnt cheap or quick.

If you dont have a ecm you may want to take Turbo 3 up on his offer that will have you alot of time esspecially if he includes the wiring harness and coils.

 

The front mount IC is in and the piping is fabricated and welded. The EMS i am using and already have is the MICROTECH LTX12 with dash display.

Pettit is decent but they are around 6 hours from me.

 

Carlos Gonzalez. He is very close to you.

 

'Yo

check out CLR Motor Sports in S. Flo.
hes far from ya but hes the man
serious builder serious racer
most experianced 3 rotor guy in the forum
did work for me > 10 yrs ago back when I lived down there
still runnin hard
he does pro sh*t for Mazda Speed he dont f*ck around
do a little searchin' ask around

Laters,

WsUp_