Im a little concerned about wiring up my 20b single turbo with the microtech ecu. I have both but how difficult is it going to be to trace down the wires and splice into them?

 

It pretty easy I'm going to be doing it next week on my FC.

http://www.microtechusa.com/Download...CTFIREfuel.pdf
http://www.microtechusa.com/Download...ECTFIREign.pdf

 

Cut the plugs and wire it straight to the microtech harness.

 

i didnt have the 20b harness when i got the motor so im going to have to im not so worried about wiring up to the motor as much as im wiring into the rest of the car.

 

The only plug you need on the 20B are the tps,water temp sensor, CAS if you plan on using the 20B ones(I'm leaning toward the T2 CAS). I hope you're running aftermarket injectors and coils?

 

everything is new including the rotors, housings and even the irons i was even able to get my hands on a new center iron. the only things that are not brand new are the upper and lower intake manifolds and throttle body.

I have the throttle body from my 13brew should i just use it or should i source a different one? I know that i will have to weld up the area in the upper manifold so it doesnt leak if i want to use it. sadly i dont have the 20b throttle body. i suppose i could order one if needed though.