It's time for me to clean out some of the 20b related parts I wont be using. The header flange is 1/2" thick stainless. The used down pipe is the actuall downpipe Cam fabs for the Banzai Rx7 at Pettit racing. It has two bungs for wideband and egt sensor. It will fit any 20b with the tranny mounted in the stock location. Mileage is below 5k on this part. The 20b twins are from my "D" series engine. No cracking or shaft play. The reason I'm selling the manifold is because I'm doing something a little different with my exhaust set-up on my 20b project. Also because I've moved my engine back several inches, the twins and downpipe wont fit and is why I need to get rid of them.


prices

$ 100.00 for the flange
$ 250.00 for the downpipe
$ 200.00 for the twins

 

last pic

 

Have the twins been converted to non-sequential?

 

No! The turbos are as they were when I pulled them of the engine. No mods to them. Converting them to full non-seq isn't hard to do.

 

bump!

 

RB flange is $51 why is yours $100?

 

"The header flange is 1/2" thick stainless"... RB is not stainless

 

^ Thx! RB flange also isn't 1/2" either.

 

Are your prices shipped and are you open to reasonable offers? I'd like to make one...

 

Pm me an offer!

 

Just did . Let me know.... Thanks!

 

Down pipe sold!

 

Header flange sold!

 

Taking offers on the twins.