hey guys,

just about got the 20b project buttoned up, but i went to put the hood back on yesterday, and the upper intake hits the hood. looks like about 3/4 of an inch too high. did anyone else have this problem, or do i just need to look at my mounts?

im already only a hair above the power steering rack, so I dunno how much lower i could drop the engine.

If this is a common thing, what did everyone do to modify the hood...just cut the bracing off it?

thanks,
Pat

 

i just cut out the inner shell of the hood below the hood scoop. it actually creates a pretty cool effect because when you get down and look up the hood scoop, you can see the top of the manifold where it says 3 ROTOR

 

I think i'm the only one with a 3 rotor under an n/a hood. The TII's will fit with little cutting.

 

Not the only one. It required one, small cut in mine.