Hey guys,

I bought a half finished project and the main bits left is brakes, exhaust and the engine bay wiring..

The car has had a full respray inside and out and has had some chopping in the engine bay of the stock loom. So here goes it - i had a silver s3 that i was stripping and i cut the whole engine bay loom out and have over the last few days grafted that to the one in the car.

So this afternoon i finally gave the car some 12v power and there was some strange things going on..

When the lights were switched on the motors of the lights would send them up and down continuously and there was like a constant tick - almost like when your indicator is on..

Also there is a 2 pin clip under the key barrell when cliped in the back right hand side tail light goes on..

Just wantedt to see if anyone has had any similar issues when stripping the car for paint and going back togther again?

Thanks..