Wheels not sitting flush with the mounting surface
#1
Full Member
Thread Starter
Join Date: May 2009
Location: Pittsboro,NC
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Wheels not sitting flush with the mounting surface
So I went to have some wheels mounted up to the rear of my GSL-SE and the screws on the mounting surface of the brakes are slightly raised keeping the wheel from mounting flush.
Should these screws sit flush? Is there a detriment to removing them? Or are they solely for holding the rotor in place when nothing else is mounted?
Thanks a bunch
Should these screws sit flush? Is there a detriment to removing them? Or are they solely for holding the rotor in place when nothing else is mounted?
Thanks a bunch
#2
Lives on the Forum
Go ahead and remove them. They are used to keep the drum lined up with the holes for the lugnuts. It can make it a little harder to get everything lined up when mounting the wheels, but I haven't had mine for years and never really missed them (I actually have rear discs now).
.
.