Wear tolerances on rotor housing and intermediate housing
#1
Junior Member
Thread Starter
Join Date: Jul 2003
Location: Canada
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Wear tolerances on rotor housing and intermediate housing
I will hopefully be getting my hands on a magnetic dial indicator to find out how deep the grooves are on the intermediate housing aswell as the rotor housing.
I need to know what the tolerances are.
Also, on the sides of the rotor housing (near the orange seals) there is a little bit of rust, is this ok?
How can I clean the rotor housings and the intermediate housings (the chromed side) without damaging the finish?
also, any tips on cleaning the outside of the engine components? I am planning on sticking to a color scheme for the engine bay.
And one last question, if i match up the parts that i need to the mazda factory part numbers, will the still be available from a dealer?
and a little side note, I pulled my seats today and found the ORIGINAL key under the velcro strap on the passenger side, pretty cool if you ask me.
cheers'
I need to know what the tolerances are.
Also, on the sides of the rotor housing (near the orange seals) there is a little bit of rust, is this ok?
How can I clean the rotor housings and the intermediate housings (the chromed side) without damaging the finish?
also, any tips on cleaning the outside of the engine components? I am planning on sticking to a color scheme for the engine bay.
And one last question, if i match up the parts that i need to the mazda factory part numbers, will the still be available from a dealer?
and a little side note, I pulled my seats today and found the ORIGINAL key under the velcro strap on the passenger side, pretty cool if you ask me.
cheers'
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
08-11-15 10:30 PM