I want a 48ida weber carb, and the intake to fit my 12a rx-7. Anyone wanna sell one to me?

 

sure i will sell you one! p/s they are not cheap

 

how much??

 

$900.00 complete

 

never mind
lol!

 

anyone else got this?

 

check ebay....
I almost bought one a few months back, but when I went to snipe the bid, my friggin keyboard messed up. It went for $360. A good price.
The manifold from RB is $311, and a good used 48 can be had for maybe around $300...
again, check ebay. it's better to get this stuff used.

 

Check ebay and it may help to post in the proper forum...maybe.

 

I have a 48 webber ida for ya. It comes on an 84 gsl-se with tokico illuminas, eibach springs, and a new 444 limited slip rear end. Racing beat header, the works. You can have it all for $2500. Im tired of working on cars. I think Im going to spend my money on my new Matrix instead.

 

I wanta buy an '83 gauge cluster...what happened? In the meantime, here's for all the Weber fans....a new source some of you might not be aware of...

 

How much you willing to spend? I've got one from an 83 GSL, if you're interested. Odometer reads 151K.



Make me an offer, and it's yours.

 

i already sold it to him sorry^^

 

i still want the carb and the manifold! i can pay 300 for them!

 

good luck finding the webber and intake for that price.if that is all you want to spend you might want to look in to buying a holley 600cfm.

 

well i want the 500 cfm but i dont know anthing about carbs and i want to know how and all i need to do a holly set up you want to help?

 

all you need is a intake for the holly or eldebrock.any american style carb.I would prefer to put a 600 vacume secondaries instead of the 500.you would also need a better fuel pump to run the 6 psi you need.

 

ok so i get a 600 cfm carb and the intake that goes with it!
then it bols on... i am buying a holley red pump and a holley fuel pressure reg. but is that it?
also i removed my rats nest so would that effect it?

 

thats all you need to buy. all you have to do is reroute the oil lines to the carb put a bracket for your throttle cable.you will also have to get those little round gaskets for the water ports for the intake.or just seal them with quarters.
p.s what is rat nest?

 

can you guys change your avatars?

scrolling through this thread it looked like the same person was asking/answering their own questions.

 

rats nest+emissions stuff so i have like three or four hoses instead of 50 all over the place a have no cats either!

 

Holy ****! I have a Weber 48 IDA on my 13B right now with a Cartech turbo kit. I had no idea they were worth that much. Damn.

 

i really need one of these webers! or one of the sd carbs with manifold!

 

here

 

i know but i need them cheaper than that!

 

Is the Weber 48ida sidedraft or downdraft?