I believe i had seen that i would need some other throttle cable because the GSL-SE one is too long. Which Throttle cable do I use?
Also, is there anything else i need from a 2nd gen besides the T2 starter?
Will my regular GSL-SE clutch slave work or does it need to be changed aswell?


Thanks

 

you need a t2 throttle cable, prolly. the gsl-se on is the shortest, and the t2 is the longest, on a lhd 13bt the throttle cable has to loop around the engine bay and pull toward the right

mike

 

I used the one that came in my GSL. Didn't have a problem with it. It just loops back into the throttle linkage. You should be able to use the clutch slave. I didn't change mine.

 

If you do the TB mod at the same time you do the swap, you can stick to the -SE one. All I did was turn around the lever arm on the shaft so it pulls open toward the drivers side. Then I made a custom cable bracket that attaches to the area that the old thermo pellet went. I of course used the 12A one (car's a GS)... its the shortest I believe.

 

I made my own cable form cable parts obtained from a cycle jet ski shop.