Strange request
#1
Full Member
Thread Starter
Join Date: Nov 2005
Location: DC
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
Strange request
One of my other projects is restoring my '57 Morgan and I'm looking to convert my front drum brakes to disks. Since buying parts from later model Morgans would cost about twice the price of my RX7, I'm looking to use readily available (ie. cheap) parts. So, if someone has a spare strut sitting around the house, could I impose on you to take a few measurement of the spindle. Following the attached diagram, could you measure the width of A, B, C, D and E. Also, the diameter of A, B and D.
I'm also thinking about using a GSL-SE rear end. Does anyone know if it's possible to narrow the rear end? I know Drag racers do it all the time with Ford rears, is their any reason it can't be done with an RX7?
Thanks
I'm also thinking about using a GSL-SE rear end. Does anyone know if it's possible to narrow the rear end? I know Drag racers do it all the time with Ford rears, is their any reason it can't be done with an RX7?
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
MILOS7
3rd Generation Specific (1993-2002)
0
09-18-15 03:39 PM