Stock rear end width
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: Mar 2002
Location: Las Vegas, NV
Posts: 4,236
Likes: 0
Received 0 Likes
on
0 Posts
Stock rear end width
Anyone know the stock rear end width? Trying to decide if i want to buy a complete 8.8 from Granny's or make my own..
#2
Senior Member
Join Date: Jul 2004
Location: Delhi, CA
Posts: 444
Likes: 0
Received 0 Likes
on
0 Posts
rear axle width
I believe I measured 57 inches on my SA. Track is 55 inches with 25mm offset wheels.
If you are doing an axle swap you may want to start with the wheels you want to run so you can place the wheel at the right position. Then have the axle built to suit.
Note that the 12A cars are a bit different than the 13B (GSL-SE). The wheels have different offset to compensate for this. (the SE axle is wider by some amount?)
I don't have an SE so I can not verify this.
If you are doing an axle swap you may want to start with the wheels you want to run so you can place the wheel at the right position. Then have the axle built to suit.
Note that the 12A cars are a bit different than the 13B (GSL-SE). The wheels have different offset to compensate for this. (the SE axle is wider by some amount?)
I don't have an SE so I can not verify this.