Stereo Panel Removal Question
#1
Junior Member
Thread Starter
Join Date: Mar 2006
Location: Sacramento
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Stereo Panel Removal Question
I'm going to be replacing the grey stereo panel/dash surround with an NOS piece I picked up for $60 bucks (with ashtray) on eBay. I know there are two screws at the bottom, once I take those out does the console surround just "pop out"? Thanks in advance for the assistance. Kevin
#2
Have RX-7, will restore
iTrader: (91)
no, take off the blower **** and the temp **** and located behind each one is a nut and a washer. you can get them with needlenose pliers. then you have three light connectors: the ashtray light, and a light that illuminates the blower **** and a light that illuminates the heat temp. all three twist out counter clockwise
#3
Right near Malloy
iTrader: (28)
Join Date: Dec 1999
Location: Behind a workbench, repairing FC Electronics.
Posts: 7,841
Received 511 Likes
on
346 Posts
Even after you get the nuts under the ***** off, the fit is pretty tight around those shafts, so you still may crack it. Get it off carefully.
Once off, I suggest carefully reaming the holes for the **** shafts so that it slips on and off easier.
Once off, I suggest carefully reaming the holes for the **** shafts so that it slips on and off easier.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
msilvia
3rd Generation Specific (1993-2002)
28
04-14-16 12:58 PM