Size of the actual wankel
Thread Starter
Full Member
Joined: May 2005
Posts: 53
Likes: 0
From: austin TX
Size of the actual wankel
I'm building a custom audio setup and making the triangle out of fiberglass but I've been looking and cant find the exact dimensions. Anyone have a clue or can point me to the right direction?
www.RPNW.org Member
Joined: Jan 2004
Posts: 329
Likes: 0
From: McMinnville, OR
I have a 13B rotar sitting on my desk.
It measures approximately 7 1/8" tall tip to tip and 3 1/8" wide.
The 12A rotar is the same height and I beleive 10mm smaller in width than the 13B.
It measures approximately 7 1/8" tall tip to tip and 3 1/8" wide.
The 12A rotar is the same height and I beleive 10mm smaller in width than the 13B.
Pull one out of your engine, then you will have an exact pattern. 
Seriously, if you want a true replica, I can do a rubbing of one that I have out and mail it to you. Just PM me and let me know.
Seriously, if you want a true replica, I can do a rubbing of one that I have out and mail it to you. Just PM me and let me know.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
Aug 9, 2018 05:54 PM
ray green
1st Gen General Discussion
2
Sep 2, 2015 06:35 AM
rx8volks
Canadian Forum
0
Sep 1, 2015 11:02 PM