So i checked Moses's thread on removing the rats nest. All the pics don't show up =/


So, What exactly do i need for this?

AC & CV Cover plate, Heat Exchanger cover plate. Is that all?


And any updated recent post's on how to remove this correctly? Thanks.

 

Dori- not sure how many of these links still active:
https://www.rx7club.com/attachment.p...chmentid=97429
https://www.rx7club.com/forum/privat...m&pmid=3371324
https://www.rx7club.com/forum/privat...m&pmid=3374017

https://www.rx7club.com/1st-gen-archive-71/fuel-intake-rats-nest-removal-79-rx-7-pictoral-457961/
https://www.rx7club.com/1st-generation-specific-1979-1985-18/serious-idle-problems-422554/page2/
https://www.rx7club.com/forum/showthread.php?t=674421

Racing Beat sells BOTH cover plates needed for this and pineapppleracing.com sells the correct yoo-hoo belt to run the Alt/W.pump once air pump is removed ($15)

Stu Aull
80GS
Alaska

 

This is what I used to remove the Rats nest. Others did a simpler set up with sucess but so far I had no issues.
4 Feet 5/32 Vacuum hose
2 Feet 5/16 Vacuum hose
1 - 5/32 T-Fitting
1 - 5/16 T-Fitting
3 - 5/32 vacuum cap
1 - Universal Fitting (plastic piece that allows 2 different size ends)
1 - Ring terminal 16-14 gauge (replaces original ground) wait to buy will need to make sure a 12mm bolt that holds the rats nest rack will fit it.

Make sure if your taking out the ACV you have a exhaust system to install.

For the exhaust system. You will need those block off plates and gasket sealer. Pineappleracing also has copper nuts for the engine studs. I didn't go with the yoo-hoo belt I used the dual pulley from re-speed. There is lots of options to go with, Pm me if you need any help


Good luck!
Chris