rx7 flood problem
#1
Full Member
Thread Starter
Join Date: Nov 2007
Location: new york city
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
rx7 flood problem
wassup everyone im having a problem with a 1st gen i just bought it has a 12a motor in it the problem the car for some reason the gas is going down my exaust manifold to my exaust pipe. I also took out the spark plugs and they where pretty wet . I check the oil in the motor and it had gas mix with the oil? Can some one help out.
Thank you
Thank you
#2
Smoke moar
Clean the spark plugs, I've herd run seafoam? I use ATF on my 2nd gen just pull both top plugs and pour it in (Use a funnel lol), replace plugs, turn over.
Well thats alot of gas, I keep my friends 79SA running well I've seen his plugs soaked, never bothered to look in the exhaust manifold. Now of course gas will go down the exhaust when its not starting, eventually it'll evap though.
Your oil smells like gas and has that shiny appeareance to it? Change your oil good before you do the above :X, gas in the oil is blowby/weakened o-ring seal. It's normal to an extent, my oil was like that after some bad flooding, now it just smells a tad like gas but no shiny look.
Well thats alot of gas, I keep my friends 79SA running well I've seen his plugs soaked, never bothered to look in the exhaust manifold. Now of course gas will go down the exhaust when its not starting, eventually it'll evap though.
Your oil smells like gas and has that shiny appeareance to it? Change your oil good before you do the above :X, gas in the oil is blowby/weakened o-ring seal. It's normal to an extent, my oil was like that after some bad flooding, now it just smells a tad like gas but no shiny look.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
82streetracer
Haltech Forum
11
03-11-19 05:34 PM