Rotary Engineering any good?
Thread Starter
Banned. I got OWNED!!!
Joined: Jan 2002
Posts: 984
Likes: 0
From: Da Barrio!!!(Irving, Texas)
Rotary Engineering any good?
I might have found an intake made buy Rotary Engineering. It is the type with the dual carbs, and wondered if they are any good? Also where to buy them new, if they have a website, and do they still exsist? I can't find anything under there name when I searched! LATERZ,
Andrew
Andrew
They went out of business back in the early 90's. When they were around, their products were very good. I had a Rotary Engineering header that I got in 88 that I was still using last year, until I got rid of the engine.
The AUTO DOCTOR
Joined: Mar 2001
Posts: 1,952
Likes: 0
From: South Side of ATL. Ga.
well i got 1 just recently and plan to slap it on myported motor SOON. i have been told this is 1 of the best intake you can get....per mr bell. i also know that my ported 12a with a 48dellorto got WAXED by a friends stock ported 180k 12a with the r.e. intake till i hit 3rd and opend the ports good 
Undercover
Joined: Aug 2001
Posts: 1,983
Likes: 0
From: Ohio
I own a pair of billistein coilovers that are on my rx-3 that have camber plates and they were assembled by Rotary Engineering. I also have 2 headers that are RE. They made quite a few of those dual 36dcd's manifold setups for the 13b 4 ports and the 12a. they make good pwr. good comapny but not around any more.
CJG
CJG
