on page 11 of the rats nest tutorial the "elbow" is removed - do you use a block off plate to cover the hole removing it leaves or is it just left open/exposed?

also when you remove the ACV - there is a small vacuum line going towards the front of the car which tee's off and head to the carb. this is on a 83 GSL 12A. is this plugged at the T or are all the vacumm lines removed here and capped at there source.

thanks, njw

 

Cap the tee.

Make a block off plate where the elbow was, or buy one from Racing Beat.

 

I can't find the one at RB. I can find the ACV one, but not the other one... :S

Anyone care to direct link?

Jon

 

I think I used this one on my car. It says 76-80 though.

 

hi
is the one you need?
the racingbeat part number is 16325
hope this helps
Don

 

Yep, that's the one. It says 76-80, but it worked just fine on my car.

 

sorry 2 hyjack this post but is there a ratsnest tuturoial for the se's? or can the same one be used, if so can someone hook it up with the site, thnx