Im removing the emissions wires from my wiring harness. My question is how do I get those prongs to come out of the main harness clip? and also if I just rip the wire out and leave the prong is there any issue with that?

 

go to wallmart, or canadian tire, or even the dollar store and get the whole small screw driver set for a few bucks and take them out like that ... its really so much easier.

 

To specify...
you need a tiny flathead screwdriver. Look carefully down in where the prongs stick out. They have a little metal tab bent back on two sides. Slide the screwdriver in and flatten it (they're soft). Then just pull the prong out from the other side. With good light and the little screwdriver its pretty easy and quick.

 

ok another little problem. I need to keep this orange plug that hooks up to my carb but I dont need the green plug on the harness. This green plug however shares a red wire with the orange plug.

 

Yea you will run in to that depending on how much you remove.