z_a_k

i have the MSD 6A that im about to put on my GFs GSL-SE but the kicker is i have two leading FC coils to use do i cut out the ignitors like for the FC direct fire set up and fun the MSD wiring to the coils inside the FC coils or what? the direct fire write up im referring to is here;

https://www.rx7club.com/1st-gen-archive-71/electrical-easy-2nd-gen-direct-fire-install-20-minutes-398818/

Thanks,
Zak

Siraniko

iTrader: (13)

without opening that link:
gut the igniter for a much more secured connection and to keep the stock appearance.

FC leading coil:
Clip the 2 wires from coil to igniters. then run teh thin red and black wires from MSD to FC coil

z_a_k

ok so basically all i need to do is just use the FC coils and discard the igniters and all the other crap out of the casing so i can keep the extra stuff i dont need to worry about down to a minimum is what im understanding, i'll throw it together tomorrow and post results

Siraniko

iTrader: (13)

edited: found pix of my sons fb with lazy *** dellorto. it seems i just snipped off the wires and kept everything in tact particularly so there is no need to fabricate a mounting bracket

z_a_k

good idea! thanks for the help