QUICK HELP (searched) engine on stand
#1
Full Member
Thread Starter
Join Date: Nov 2008
Location: poulsbo
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
QUICK HELP (searched) engine on stand
so i bought the ATKINS engine stand. and it didnt come with hardware. I have the 750lb harbor frieght enigine stand and i dont have anyway to get it on. From what im reading if i pull the studs out of the front iron i can use my own bolts only i dont have a tool to do it and i have toi have my buddys dads cherry picker back tonite and im moving the engine to my brother-in-laws because i dont have a garage. I have 2hrs to figure this out. I already went to HOME DEPOT to get some bolt to thread on the studs and thats a no go and im searching and searching and getting no where. please help! thanks _noel
#2
I touch my Wankel.
iTrader: (1)
Join Date: Aug 2007
Location: Muskegon, MI
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
I never used an adapter when I put my engine on a stand. If I remember correctly there are 4 studs/threaded holes on the front iron. 2 are 10x1.25 (?) and the other 2 are 12x1.5 (same as lug bolts). I just bought some longer bolts and threaded them in.
Not the greatest picture, but hopefully you get the idea.
Not the greatest picture, but hopefully you get the idea.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM