Pulsation Damper replacement
#1
Full Member
Thread Starter
Join Date: Nov 2004
Location: Echterdingen, Germany
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
Pulsation Damper replacement
I'm about to replace my pulsation damper on my 85 SE and needed some guidance on how to do it. Can anyone give me a step-by-step guide on how to do it? Is it something I can do myself or do I need help from another person?
#2
I replaced mine without removing any other parts. On replacement, getting the 2 new copper crush washers (seals) in place as you move the 'bolt section' through the fittings requires some finesse.
Start with a big open end wrench to break it loose. Then unscrew with fingers. Look for 2 copper crush washers in the setup. Hope you bought those too. I got my parts from a Mazda dealer.
Start with a big open end wrench to break it loose. Then unscrew with fingers. Look for 2 copper crush washers in the setup. Hope you bought those too. I got my parts from a Mazda dealer.
#3
Full Member
Thread Starter
Join Date: Nov 2004
Location: Echterdingen, Germany
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the advice. Definitely sounds good not having to take apart alot of things to get to it. I'll have to order the part then get on it before I drive the car.
Thread
Thread Starter
Forum
Replies
Last Post
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM