75beetle

Can any of ya guys give me a link to a step by step , vacuum hose deletion

THanks for your help

Or if anyone lives near greeneville Tn help me do it

Rx-7Doctor

iTrader: (13)

Are you doing a rats nest removal?

75beetle

idk im getting rid of the vacuum hoses so i guess the rats nest deletion

Jeezus

iTrader: (4)

https://www.rx7club.com/1st-gen-archive-71/emissions-rats-nest-close-up-pics-711693/
https://www.rx7club.com/1st-gen-archive-71/fuel-intake-rats-nest-removal-79-rx-7-pictoral-457961/

75beetle

These links didnt give me step by step instruction

Jeezus

iTrader: (4)

Re-read the 2nd link.

Jeezus

iTrader: (4)

Here is my engine bay. No rats nest.



I don't remember it fully, but I can tell you this. Remove the rats nest and all the hoses. Should be 2 or 3 12mm bolts. One will have a ground, make sure to put that back, it needs to be grounded. I don't have it, and can't find where it went, but I have no problems.

MECHANICAL ADVANCE:

T the 2 lines together


Then run the line to the 2nd from the left nipple. I used windshield washer hoses, they were like 1$ a foot.


This is the PCV system. Run a length of hose from this nipple on the manifold:


With a PCV. I used a 90's dodge caravan 3.0, maybe 5$ from advance auto. Here you can see the PCV and the nipple on the IRON.


The nipple on the oil fill tube should have a filter put on it. I currently don't have one, it was on another car.


Here is what is left with my harness. One plug for the carb, one plug for the water pump.