Need help installing distributor
#1
Troy
Thread Starter
iTrader: (1)
Join Date: Dec 2009
Location: California
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
Need help installing distributor
I have a 1984 GSL-SE and in replacing the distributor somehow I got myself jacked up..it starts but runs like crap, if I get the yellow mark lined up with the mark, which direction should the rotor be pointing? L1,L2?
thanks,
troy
thanks,
troy
#2
My 7 is my girlfriend.
iTrader: (5)
Join Date: Feb 2006
Location: London, Ontario, Canada
Posts: 3,162
Likes: 0
Received 1 Like
on
1 Post
Remove the distributor and down on the gear there will be a mark on the gear and the shaft. Line those up and install the dizzy with those facing the 12o'clock position as you are standing on the drivers side looking at the engine. If it still won't start or idle then take it out and adjust the gear a tooth forward or back and try again. The rotor will turn a bit as your sliding the gear into place. It sounds like you did what my engine builder did and it's off one tooth. It would fire with a bit of a fight, had no power and wouldn't idle below 1500. He showed up and after some checking to make sure he didn't screw up something else on the build he pulled the dizzy and turned it a touch and it fired and ran like a brand new Civic.
#4
Troy
Thread Starter
iTrader: (1)
Join Date: Dec 2009
Location: California
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
thanks
okay i found the dimple and the mark on the gear so i am good there, to my original post; do i need to have the yellow mark perfectly aligned with the timing mark on block to slip the dizzy in because i noticed it pulls out whenever..?
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM