Well here is my 12 SP with Holley 465 installed and you can see pics of my SDJ headers installed too. Let me know of the setup. I know the engine bay isn't the cleanest but i'm working on that ... just removing all that wax stuff from the engine bay is a pain in the ****.

http://img185.imageshack.us/img185/2...ture0566wb.jpg
http://img185.imageshack.us/img185/5...ture0573eq.jpg
http://img185.imageshack.us/img185/3...ture0591jf.jpg

 

 

Very good looking header.

Nice looking engine too!

 

thanks hades for putting them up like that .. wasn't sure if this website would allow me or not. Thanks again

 

Glad to help.

 

Looks pretty good, other than the beehive. I reccommend an FC FMOC to ensure the engine gets plenty of cool oil.

 

Ya i've got a GSL/SE one sitting at home and I just need to mount it. Just need new rubber O rings to use though. Now i've been told that I should use the SE rad too because its wider and has more cores in there? I've also heard that its a bit shorter due to the oil cooler. being mounted at the bottom?

 

as far as I know, the SE radiator is the same as 12a in the S3's. I got mine from radiator.com for ~120 shipped to my door in 2 days

 

Looks really good dude! Did you but it new or used and how much did it run ya? I actually need/ am looking for a 600 racing beat holley for my 1/2 bridge ported motor. So if you have one, PM Me!!

 

The carb I bought used form a forum member here for 400$ shipped came with lots of goodies.