my 1st rebuild.
#1
707
Thread Starter
Join Date: May 2004
Location: Santa Rosa Ca
Posts: 854
Likes: 0
Received 0 Likes
on
0 Posts
my 1st rebuild.
first opened up.
ported
just checking inplay i installed the thrust washer nuts before i did fyi. (and cleaned the counter weight)
this is before i painted the intake manifold.
mods will be
light weight flywheel
side draft mukuni
RB collected header
engine
12a street port all three irons intake and egsuast
all new oem seals and 93+ corner springs
ported
just checking inplay i installed the thrust washer nuts before i did fyi. (and cleaned the counter weight)
this is before i painted the intake manifold.
mods will be
light weight flywheel
side draft mukuni
RB collected header
engine
12a street port all three irons intake and egsuast
all new oem seals and 93+ corner springs
#2
RX HVN
iTrader: (2)
Congrats Rexy- lookin good - you are ahead of me on my rebuild.
Done the cleaning, organizing, painting but still awaiting a center iron, so I think I am done till spring (no garage, and unheated shed won't cut it in Alaska over winter)
'Luck on the start up!
Stu Aull
80GS
Alaska
Done the cleaning, organizing, painting but still awaiting a center iron, so I think I am done till spring (no garage, and unheated shed won't cut it in Alaska over winter)
'Luck on the start up!
Stu Aull
80GS
Alaska
Trending Topics
#8
707
Thread Starter
Join Date: May 2004
Location: Santa Rosa Ca
Posts: 854
Likes: 0
Received 0 Likes
on
0 Posts
#13
707
Thread Starter
Join Date: May 2004
Location: Santa Rosa Ca
Posts: 854
Likes: 0
Received 0 Likes
on
0 Posts
#20
707
Thread Starter
Join Date: May 2004
Location: Santa Rosa Ca
Posts: 854
Likes: 0
Received 0 Likes
on
0 Posts